UltraShift PLUS
TRSM0940 EN-US
|
March 2024 - A

Low Capacity Inertia Brake (LCIB)

Special Instructions

None

Special Tools

  • Basic hand tools

Component Identification

_Graphics/LineArt/LCIB.png

1. Mounting Nuts (x2)

2. Low Capacity Inertia Brake (LCIB)

LCIB Removal

Note: The Transmission, Cross Shaft, Release Yoke and ECA must be removed prior to removing the LCIB.

  1. Remove the 2 mounting nuts with a breaker bar and socket.

    _Graphics/Web/TRTS0980_lcib 1.png

  2. Remove the LCIB by hand by sliding off of the splined Input Shaft.

    _Graphics/Web/TRTS0980_lcib 2.png

LCIB Installation

  1. Slide the LCIB onto the splined Input Shaft while centering the holes onto the retaining studs.

    _Graphics/Web/TRTS0980_lcib 2.png

  2. Install the 2 retaining nuts and torque nuts to 140–150 lb-ft (190–203 N•m).

    Note: The LCIB can only be installed one way. The label is toward the right side of the vehicle and facing the flywheel.

    _Graphics/Web/TRTS0980_lcib 1.png