Fuller Advantage
TRSM0980 EN-US
|
October 2022 - B

Electronic Clutch Actuator (ECA) Speed Sensor

Special Instructions

None

Special Tools

  • Basic hand tools

Component Identification

_Graphics/LineArt/TRSM0980_MainShaftSpeedSensorID.png

1. 2-Way Electronic Clutch Actuator (ECA) Speed Sensor

Electronic Clutch Actuator (ECA) Speed Sensor Removal

  1. Disconnect the Transmission Harness from the Electronic Clutch Actuator (ECA) Speed Sensor.

    _Graphics/Web/TRSM0980_ECASpeedSensor 1.jpg

  2. Using a 6-point reverse torx bit, remove the bolt from the retaining clip.

  3. The clip will not remove from the speed sensor. Remove the ECA Speed Sensor with O-ring, from the Clutch Housing.

    _Graphics/Web/TRSM0980_ECASpeedSensor 2.jpg

Electronic Clutch Actuator (ECA) Speed Sensor Installation

Notice
Clean the mounting surface on the housing and remove any burrs or sharp edges.
Notice
Lubricate the O-ring with Eaton Fuller silicone 71214 or equivalent.

  1. Using a smooth twisting motion; fully insert the Electronic Clutch Actuator (ECA) Speed Sensor in the Transmission Clutch Housing on the lower left hand side.

    _Graphics/Web/TRSM0980_ECASpeedSensor 2.jpg

  2. Using a 6-point reverse torx bit, install the retaining bolt and tighten 7–9 lb-ft (9–12 N•m).

    _Graphics/Web/TRSM0980_ECASpeedSensor 3.jpg

  3. Reconnect the ECA Speed Sensor pigtail to the Transmission Harness.

    _Graphics/Web/TRSM0980_ECASpeedSensor 1.jpg