Fuller Advantage
TRSM0980 EN-US
|
October 2022 - B

Input Shaft Speed Sensor

Special Instructions

None

Special Tools

  • Basic hand tools

Component Identification

_Graphics/LineArt/TRSM0980_MainShaftSpeedSensorID.png

1. 2-Way Input Shaft Speed Sensor

Input Shaft Speed Sensor Removal

  1. Disconnect the Transmission Harness from the Input Shaft Speed Sensor or pigtail connector, if equipped.

    _Graphics/Web/TRSM0980_Input 1.jpg

  2. Using a 3/8” socket, remove the sensor retaining bolt.

    _Graphics/Web/TRSM0980_Input 2.jpg

  3. Remove the Input Shaft Speed Sensor, with O-ring, from the Transmission Shift Bar Housing.

    _Graphics/Web/TRSM0980_Input 3.jpg

Input Shaft Speed Sensor Installation

Notice
Clean the mounting surface on the housing and remove any burrs or sharp edges.
Notice
Lubricate the O-ring with Eaton Fuller silicone 71214 or equivalent.

  1. Using a smooth, twisting motion, fully insert the Input Shaft Speed Sensor in the Transmission Shift Bar Housing opening.

    _Graphics/Web/TRSM0980_Input 3.jpg

  2. Using a 3/8” socket, install the retaining bolt and tighten to 8–10 lb-ft (11–13 N•m).

    _Graphics/Web/TRSM0980_Input 2.jpg

  3. Reconnect the Transmission Harness to the Input Shaft Speed Sensor or pigtail connector, if equipped.

    _Graphics/Web/TRSM0980_Input 1.jpg