Main Shaft Speed Sensor (TRSM0980)

Fuller Advantage

TRSM0980 EN-US

October 2022 - B

Main Shaft Speed Sensor

None


1. 2-Way Main Shaft Speed Sensor

Disconnect the Transmission Harness from the Main Shaft Speed Sensor pigtail.
Use a 6 point reverse torx. Remove the bolt from the retaining clip.
The clip will not remove from the speed sensor. Remove the Main Shaft Speed Sensor, with O-ring, from the rear of the Shift Bar Housing.

Notice

Clean the mounting surface on the housing and remove any burrs or sharp edges.

Notice

Lubricate the O-ring with Eaton Fuller silicone 71214 or equivalent.

Use a smooth twisting motion; fully insert the Main Shaft Speed Sensor in the rear Transmission Shift Bar Housing bore
2. Use a 6 point reverse torx. Install the retaining bolt and tighten 7–9 lb-ft (9–12 N•m.)
Reconnect the Main Shaft Speed Sensor pigtail to the Transmission Harness.