Fault Code 151: ASR Brake Control Active
J1939: SA 3 SPN 562 FMI 13, 19
Overview
The Transmission Control Module (TCM) receives the vehicle’s Anti-Slip Regulation (ASR) Brake Control Active message over the Primary Data Link. This information is used to determine transmission operation.
Detection
The TCM monitors the ASR Brake Control Active message. If a failure is detected the fault is set Active.
Conditions to Set Fault Code Active
FMI 13 - Out of Calibration: ASR Brake Control Active message not available for 5 seconds.
FMI 19: ASR Brake Control Active message invalid for 5 seconds.
Fallback
FMI 13, 19:
- Amber warning lamp on
- Engine commanded features prohibited
Conditions to Set Fault Code Inactive
FMI 13, 19: ASR Brake Control Active message.
Possible Causes
FMI 13, 19:
- Vehicle Components
- Module(s)
- ASR Brake Control Active message
- Primary Data Link
Additional Tools
- None
Fault Code 151 Troubleshooting
Record the transmission fault codes, FMIs, occurrences, and timestamps from the Service Activity Report created during the Diagnostic Procedure.
If Fault Code 151 is Inactive and there are other Active vehicle or transmission fault codes, troubleshoot all Active fault codes.Go to Step V
If Fault Code 151 FMI 13 is Active, refer to OEM and enable vehicle ASR Brake Control Active SPN 562. Go to Step V
If Fault Code 151 FMI 13 is Inactive, Go to Step V
If Fault Code 151 FMI 19 is Active or Inactive, refer to OEM guidelines regarding ASR Brake Control Active message repair or replacement. Go to Step V
Key off.
Reconnect all connectors and verify that all components are properly installed.
Key on with engine off.
Connect ServiceRanger.
Go to “Fault Codes”.
Select “Clear All Faults”.
Operate vehicle and attempt to reset the fault code or duplicate the previous complaint.
Check for fault codes using ServiceRanger.
If no fault codes set and the vehicle operates properly, test complete.
If Fault Code 151 sets Active during operation, Go to Step A
If a fault code other than 151 sets Active, troubleshoot per Fault Code Isolation Procedure Index.